My-shield® Hospital Disinfectant With Zetrisil – 5 Gallons

$150.20

My-shield® Hospital Disinfectant is an EPA registered (94196-3) Nano-silicone “Zetrisil” based product, safe and easy to use on all surfaces (including fabrics). My-shield® Hospital Disinfectant when used as directed, kills odor, bacteria & viruses.

1

Qty:
Compare

Description

Description

Kills odors, bacteria & virus’s when used as directed, Kills 99.9% of “Corona virus”

Low in toxicity, Bleach & Chlorine-free: Most Hospital Disinfectants available on the market today contain harsh compounds that have been found to be highly toxic & corrosive and very hazardous to human health & the environment.

Quick & easy to apply: My-shield Hospital Disinfectant comes in a ready-mixed solution with no dilution required. Small surface areas: Can be sprayed directly onto a surface or item and allowed to dry. Alternatively, wipes or hand-held spray packs can be applied directly onto any surface or item. For large surface areas: (e.g. building interiors) An electrostatic sprayer can be used to easily disperse the disinfectant to all surfaces within a room including walls, ceilings, flooring, furniture, etc. Drying time with this application is very quick and the procedure is complete within minutes. 

EPA Approved (#94196-3): NON-PUBLIC HEALTH USE, LOCATIONS & CLAIMS ON NON-POROUS HARD SURFACES:

When used as directed, My-shield Hospital Disinfectant will kill and control bacteria and viruses, on all non-porous hard surfaces, including Hospitals, Nursing Homes, Health Care, Public Transport, Hotels. Motels, Leisure, Sporting Arenas,  Hospitability, Schools, Educational Facilities, Mosques, Gymnasiums, Government and Military.

Made in the USA

Additional information

Weight 20.236 kg
Dimensions 38.1 × 38.1 × 38.1 cm

Ingredients + Directions

PRECAUTIONARY STATEMENTS:

HAZARDS TO HUMANS AND DOMESTIC ANIMALS
CAUTION: KEEP OUT OF THE REACH OF CHILDREN

CAUTION. Harmful if swallowed. Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco, or using the toilet. Harmful if absorbed through skin. Avoid contact with skin, eyes or clothing. Wash thoroughly with soap andwater after handling and before eating, drinking, chewing gum, using tobacco, or using the toilet. Remove and wash contaminated clothing before reuse. Wear (long sleeved shirts and pants, if applicable). Harmful if inhaled. Avoid breathing (vapor or spray mist). Remove and wash contaminated clothing before reuse.

ENVIRONMENTAL HAZARDS COMMERCIAL AND INDUSTRIAL USES:
This pesticide is toxic to fish. Do not discharge effluent containing this product into lakes, streams, ponds, estuaries, oceans, or other waters unless in accordance with the requirements of a NationalPollutant Discharge Elimination System (NPDES) permit and the permitting authority has been notified in writing prior to discharge. Do not discharge effluent containing this product to sewer systems without previously notifying the local sewage systems without previously notifying the local sewage treatment plant authority. For guidance, contact your State Water Board or Regional Office of the EPA.

ACTIVE INGREDIENTS:

Alkyl(C14-50%, C12-40%, C16-10%) Dimethyl Benzyl Ammonium Chloride 0.4000%
Octyl Decyl Dimethyl Ammonium Chloride 0.3000%
Dioctyl Dimethyl Ammonium Chloride 0.1200%
Didecyl Dimethyl Ammonium Chloride 0.1800%
Poly (hexamethylenebiguanide) hydrochloride 0.5000%
(3-Trimethoxysilyl) propyl dimethyloctadecyl ammonium chloride 0.7920%
Other Ingredients 97.7080%
TOTAL 100.00%

STORAGE AND DISPOSAL Do not contaminate water, food or feed by storage and disposal. Pesticide Storage: Store in original, tightly closed containers below 30°C (86°F) and above 0°C (32°F) in a secure area inaccessible to children and away from food or feed. Pesticide Disposal: Wastes resulting from the use of this product may be disposed of on site or at an approved waste disposal facility. Container Handling: {containers less than 5 gallons} Do not reuse or refill this container. Triple rinse container as follows: Empty the remaining contents into application equipment or a mix tank and drain for 10 seconds after the flow begins to drip. Fill the container 1/4 full of water and recap. Shake for 10 seconds. Pour reinstate into application equipment or a mix tank or store reinstate for a later use or disposal. Drain for 10 seconds after the flow begins to drip. Repeat this procedure two more times. Then offer for recycling if available or puncture and dispose of in a sanitary landfill, or by other procedures approved by state and local authorities.

FIRST AID: IF INHALED: Remove victim immediately from source of exposure. Move person to fresh air. If person is not breathing, call 911or an ambulance, then give artificial respiration, preferably mouth-to-mouth, if possible. Call a poison control center or doctor for further treatment advice. IF SWALLOWED: Call a poison control center or doctor immediately for treatment advice. Have person sip a glass of water if able to swallow. Do not induce vomiting unless told to do so by a poison control center or doctor. Do not give anything by mouth to an unconscious person. IF ON SKIN OR CLOTHING: Take off contaminated clothing. Rinse skin immediately with plenty of water for 15-20 minutes. Call a poison control center or doctor for treatment advice. IF IN THE EYES: Immediately flush with plenty of water for up to 15 minutes. Hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses (if present) after the first 5 minutes, then continue rinsing. Call a doctor for treatment advice. EMERGENCY CALL INFO: +1(888) 331-8332, M-F, 9AM-5PM (EST)

DIRECTIONS FOR USE:
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.

PUBLIC HEALTH CLAIMS – DIRECTIONS FOR USE ON NON-POROUS HARD SURFACES:
This product is not to be used as a terminal sterilant/high level disinfectant on any surface or instrument that (1) is introduced directly into the human body, either into or in contact with the bloodstream or normally sterile areas of the body, or (2) contacts intact mucous membranes but which does not ordinarily penetrate the blood barrier or otherwise enter normally sterile areas of the body. This product may be used to preclean or decontaminate critical or semi-critical medical devices prior to sterilization or high-level disinfection.

APPLICATION METHOD: My-shield Hospital Disinfectant, when used as a ready-to-use spray from a distance of 6-8 inches from the surface, is an effective disinfectant with bactericidal and viricidal activity against the following on pre-cleaned hard, non-porous surfaces for a 10-minute contact time:

– Staphylococcus aureus (ATCC 6538)
– Pseudomonas aeruginosa (ATCC 15442)
– Salmonella enterica (ATCC 10708)
– 229E Human Corona Virus (ATCC VR-740)

HARD SURFACE PREPARATION:
Pre-clean surface prior to application of My-shield Hospital Disinfectant, using a trigger pump or pressure sprayer, spray 6” to 8” from the surface, making sure the surface is completely wet and remains wet for 10 minutes, reapply, if necessary, to ensure surface remains wet for 10 minutes. Let stand until dry or wipe dry after 10 minutes Remove children and pets from treated area until completely dried.

NON-PUBLIC HEALTH USELOCATIONS & CLAIMS ON NON-POROUS HARD SURFACES:
When used as directed, My-shield Hospital Disinfectant will kill and control bacteria and viruses, on all non-porous hard surfaces, including Hospitals, Nursing Homes, Health Care, Public Transport, Hotels. Motels, Leisure, Sporting Arenas, Hospitability, Schools, Educational Facilities, Mosques, Gymnasiums, Government and Military.